Step-by-Step LUMINEERS™ Porcelain Veneers
First Visit
1. Consultation
|
2. Impression Taking
|
|
Second Visit
SURFACE PREPARATION
1. Polish the teeth with Porcelain Polishing Paste and water.
|
2. Syringe Paint-On Dental Dam on lingual side of
the interproximals, covering the gums and teeth
thoroughly (this aids in clean-up). Light-cure.
|
3. Etch teeth for 20 seconds, rinse and dry.
|
4. Mix together equal amounts of Tenure® A and B.
|
5. Apply 5 coats of the A-B mixture to each tooth, or until glossy, then air-dry the tooth surfaces.
|
|
TRY-IN OF LUMINEERS
BONDING LUMINEERS
1. Select the appropriate shade of Ultra-Bond®
|
2. Apply Ultra-Bond to the prepared LUMINEERS and put in place.
|
3. After placing, remove excess Ultra-Bond with a soft brush coated.
|
4. Tack LUMINEERS in place and continue to remove excess cement with a soft brush coated.
|
5. Completely light-cure all LUMINEERS, exposing each surface for 5 seconds.
|
|
FINISHING
1. Clean up
|
2. Trim/polish the margins of the porcelain veneer.
|
3. Check the bite
|
4. Polish the new smile with Porcelain Laminate Polishing Paste.
| |
|
|
|